CAS images and real MSX

By Eugeny_Brychkov

Paragon (1232)

Eugeny_Brychkov's picture

12-04-2010, 22:06

I bloaded king's valley to bluemsx, saved it to cas file (with correct parameters), coverted cas file to wav file, built a cable.

I write in basic prompt
bload"cas:",r

it says
Found:valley

it senses end of wav file (relay clicks) but in 3 seconds reboots to the basic prompt.

When I write
bload"cas:"

it says
Found:valley
Ok

then I enter the following commands
defusr=&hc800
?usr(0)

and it says (with some delay of 0.5 second)
Syntax error
Ok

Question - what is a problem? It seems image loads ok (I checked beginning - &h8800 containt 41 42, starting point c800 - f3 db a8, and at the end - it contains 81)

If I try the same with bluemsx it runs cas file (not wav one) fine. My hardware is Yamaha YIS503II.

Login or register to post comments