Looking for MODE80.COM file?

Page 1/2
| 2

By Guseco

Expert (68)

Guseco's picture

27-05-2011, 12:49

In the msxblue page manual when talks about SVI-727 extenxion mention a program named MODE80.COM to change 80 column mode.
Does anybody knows where can I find it?

Best regards,

Guseco Big smile

Login or register to post comments

By o.geerdink

Hero (587)

o.geerdink's picture

10-05-2015, 10:39

up

By gdx

Enlighted (5697)

gdx's picture

10-05-2015, 11:17

On site below in the SVI-738's ressources archive (SVI-738.zip), WIDTH80.COM (not MODE80.COM) can be found into the 738msxdos.dsk.

http://www.vik.cc/bluemsx/resource.html

By o.geerdink

Hero (587)

o.geerdink's picture

10-05-2015, 11:57

tnx

By o.geerdink

Hero (587)

o.geerdink's picture

12-09-2017, 12:10

That file is for the v9938 in the 738, i need mode80.com for the svi 727!

By NYYRIKKI

Enlighted (5943)

NYYRIKKI's picture

12-09-2017, 13:45

I know I have it somewhere, please hold on...

By NYYRIKKI

Enlighted (5943)

NYYRIKKI's picture

12-09-2017, 13:53

Found it... mail sent.

By gdx

Enlighted (5697)

gdx's picture

13-09-2017, 02:04

I would be curious to see what this command does exactly. WITH80.COM did not work?

By NYYRIKKI

Enlighted (5943)

NYYRIKKI's picture

13-09-2017, 07:09

gdx wrote:

I would be curious to see what this command does exactly. WITH80.COM did not work?

It is pretty boring stuff... It sets up raster address registers, sync positions etc to CRT controller, adjusts LINLEN and populates the standard hooks... No much to see...

Ps There is also pretty similar program called PUT9000 for V9990... though that one also adds VT100 support.

By o.geerdink

Hero (587)

o.geerdink's picture

13-09-2017, 09:36

Thanks NYYRIKKI I want to control the vdp chip in the svi 727 cartridge and see if I can use it fully.

By Manuel

Ascended (18948)

Manuel's picture

13-09-2017, 09:37

What do you want to do with it then?

Page 1/2
| 2