Using Toshiba HX-MU901 with the Philips Music Module

Por mais1976

Master (172)

imagem de mais1976

12-07-2011, 15:53

I recently bought a Toshiba HX-MU900 + keyboard.
I also own a Music Module. According to the MSX FAQ the connectors are the same, but they pins are arranged differently.
Back in the days some commodore keyboards were adapted to use with the music module in the netherlands.
I want to be able to use the keyboard with both modules.

So i was wondering:

1.) Is it possible to solder a cable with on 1 end a female plug (Toshiba) and on the other end a male plug (Philips)
2.) Are these connectors proprietary?

Entrar ou registrar-se para comentar

Por sd_snatcher

Prophet (3642)

imagem de sd_snatcher

12-07-2011, 16:36

Yes, it's possible. To build the adapter you'll need this information.

Por mais1976

Master (172)

imagem de mais1976

12-07-2011, 17:01

Thanks sd_snatcher, exactly what i needed Smile I think i have to solder this one myself or Is there anyone who sells these adapter?

Por Retrofan

Paragon (1339)

imagem de Retrofan

28-10-2012, 08:57

sd_snatcher wrote:

Yes, it's possible. To build the adapter you'll need this information.

Does someone has this adapter laying around? I would like to have one if it isn't too expensive. I'm not handy with soldering.

Por Retrofan

Paragon (1339)

imagem de Retrofan

06-11-2012, 18:10

No one? Who can build it for me? Please contact me. Thanks.

Por sd_snatcher

Prophet (3642)

imagem de sd_snatcher

06-11-2012, 21:55

Come on. It's a very basic wiring adapter. Minimal soldering skills are required for this. You should try it. Smile

Por Pablibiris

Paragon (1815)

imagem de Pablibiris

10-10-2013, 00:44

Hi!
Sorry for write in an old post...but I need help with this adapter Smile
I dont understand the scheme shown on that page ... someone could show me some simpler scheme,please?
Thanks!

Por sd_snatcher

Prophet (3642)

imagem de sd_snatcher

10-10-2013, 03:29

Look at the "Connectors" tab inside that XLS file.

You just need to rewire it so every signal gets into its correct pin. Notice that the over the pins 9 & 11 is that dent that makes sure that the connector can't be connected upside-down. The pinout shown is for the male connector on the cartridge.

Por Pablibiris

Paragon (1815)

imagem de Pablibiris

10-10-2013, 09:20

Thanks sd_snatcher!
I will try to make it Smile
Regards!

Por journey

Hero (573)

imagem de journey

10-10-2018, 09:19

Hi all!

someone's able to build one for me? Smile

Por meits

Scribe (6530)

imagem de meits

16-06-2020, 21:28

Digging up an old thread while stumbling on it in search for other info about this keyboard.
It needs to be said that you will not be able to play on the keyboard if you use this adapter. Key presses will be registered in most cases, but the right note will never be played. It's all shifted a bit.