Please try [8bit4ever SX-1] + [GR8NET]

Página 2/2
1 |

Por Eugeny_Brychkov

Paragon (1195)

imagem de Eugeny_Brychkov

28-10-2018, 00:27

8bits4ever wrote:

We've tested most of the cartridges we produce (Carnivore2, SD-512, CF-640, FDC-600, FM-PAK, MSX Blaster) with the SX-1 board. We did not find any problems so far.

How do you test each SX-1 boards you produce before shipping? What is the test/validation procedure?

Por djh1697

Paragon (1635)

imagem de djh1697

28-10-2018, 22:13

Just curious, where are the two joystick connectors on the board? I only see one? is hte 2nd a header needing a joystick connector?

Por thalin

Rookie (28)

imagem de thalin

30-10-2018, 12:01

It is a header. I use an old pinheader to serial port cable.

Por thalin

Rookie (28)

imagem de thalin

05-11-2018, 09:50

Yes

Por thalin

Rookie (28)

imagem de thalin

07-03-2019, 18:59

After upgrading GR8NET to fw v0.8 the reset issue was resolved!

Por mcolom

Master (241)

imagem de mcolom

13-11-2020, 17:07

Just to add that with a center-positive PSU the board (rev 3.5a) works fine too. There isn't much info about this (excellent) board around!

Página 2/2
1 |